Two questions for the Yammy experts. Motor is an 07 90/65. #1 I’ve raised my motor a hole, and now…

31 views
0

AJ Mottola asks: Two questions for the Yammy experts. Motor is an 07 90/65.

#1 I’ve raised my motor a hole, and now my jet foot will contact my tunnel extension when trimmed all the way down. Is there a pin to prevent this? I see holes for trim pins, but can’t find it on any parts diagrams for those with power tilt and trim. Is there maybe another way to prevent the last 1/4″ of trim travel?

#2 I have a ticking sound that’s started coming from the motor leg at rpms below 1k. The shaft is greased at all contact points, I’ve pulled the jet (lower unit) looking for it, but can find nothing out of place. The only thing I can think of is that the shift rod is moving around, since with a jet, it sits empty. However, I do not see it moving at the top of the motor where the linkage is. Noises drive me nuts, and I can’t figure this one out.

Thanks for the help.


Top Skiff Links

April 6, 2018

April 6, 2018

April 6, 2018